Page 5 • JL Audio, Inc., 2015
Continued on Next Page
S T E P 16
Thread an M8 - 70 mm Set Screw into the other
factory threaded hole. Place a 1” OD x 1/2”
Steel Spacer over the screw, and thread the M8
- 70 mm Set Screw until the top is 1/4” above
the top of the 1” OD x 1/2” Steel Spacer.
S T E P 15
Thread an M8 - 70 mm Set Screw into one of
the factory threaded holes. Place a 1” OD x
1/2” Steel Spacer over the screw, and thread
the M8 - 70 mm Set Screw until the top is 1/4”
above the top of the 1” OD x 1/2” Steel Spacer.
S T E P 14
Note: Steps 14-18 are only necessary in
vehicles not equipped with the factory
subwoofer. If vehicle does have the factory
subwoofer, skip to Step 19.
Lift up the trunk liner, and locate the two
factory threaded holes in the floor.
S T E P 13
Press the Plastic Plug into the factory hole in
the floor.
Use a heat gun to soften the Plastic Plug,
allowing it to take the shape of the factory
hole. It may be necessary to add silicone
adhesive to hold the Plastic Plug in place.
S T E P 12
Fold the trunk liner flap out of the way to
expose the other factory threaded hole in the
floor.
Thread an M8 - 70 mm Set Screw into the
factory threaded hole. Place a 1” OD x 1/2”
Steel Spacer over the screw, and thread the M8
- 70 mm Set Screw until the top is flush with
the 1” OD x 1/2” Steel Spacer.
S T E P 11
Fold the trunk liner flap out of the way to
expose one of the factory threaded holes in
the floor.
Thread an M8 - 70 mm Set Screw into the
factory threaded hole. Place a 1” OD x 1/2”
Steel Spacer over the screw, and thread the M8
- 70 mm Set Screw until the top is flush with
the 1” OD x 1/2” Steel Spacer.
S T E P 10
Remove the subwoofer enclosure bracket from
the vehicle.
S T E P 9
Remove the indicated upper subwoofer
enclosure bracket bolt.
SB-F-MUSCPE/12TW3 INSTR_SKU# 011432