Continued on Next Page
SMS-C-CTS INSTR_SKU# 011357
Page 6 • JL Audio, Inc., 2013
S T E P 2 0
Cut the Power Wire about 12” from the terminated end,
strip the end of the short section and connect it to the Fuse
Holder. Connect the terminated end to the positive battery
terminal.
Note: Do not install the fuse at this time.
S T E P 2 4
Empty out the rear seat area of the vehicle.
S T E P 1 9
Thread a 3/8 - 16 x 2-1/4” Set Screw through each of the 3/8
- 16 U-Nut on the Rear Bracket leaving approximately 1-1/4”
exposed as illustrated in
Step 12
.
S T E P 2 3
Locate the hole at the top of the driver’s side of the trunk.
Scrape away the paint around the hole, and install the
Ground Lug in the hole as shown. Connect the Ground
Wire to the Ground Lug, and route the wire to the Amplifier
mounting location.
S T E P 1 8
Reinstall the factory amplifier and reconnect each of the
wiring harnesses.
S T E P 2 2
Connect the Mini Fuse Holder to the ignition wire shown.
Connect the Remote Turn-on Wire to the opposite end of
the Mini Fuse Holder, and route the wire to the Amplifier
mounting location.
Note: Do not install the fuse at this time.
S T E P 1 7
Reinstall the computer bracket over the Side Bracket as
shown. Thread a 3/8 - 16 x 2-1/4” Set Screw through the 3/8 -
16 U-Nut, leaving approximately 1-1/4” exposed.
S T E P 2 1
Strip the end of the long section of Power Wire, and connect
it to the opposite side of the Fuse Holder. Secure the Fuse
Holder to the vehicle. Route the Power Wire to the Amplifier
mounting location.
