JL Audio m600, Руководство пользователя, Страница: 6 / 20

6 | JL Audio - M600/6-24V Owner’s Manual
TURN-ON LEAD
The M600/6-24V uses a conven12 to
24V remote turn-on lead, typically controlled
by the source unit’s remote turn-on output. The
amplifier will turn on when any voltage between
+12V and +24V is present at its “Remote” input
and turn off when this voltage is switched off. If
a source unit does not have a dedicated remote
turn-on output, the amplifier’s turn-on lead can
be connected to +12V to +24V via a switch that
derives power from an ignition-switched circuit.
Ground Remote +24 VDC
NOT FOR USE IN 12V SYSTEMS!
The M600/6-24V’s “Remote” turn-on
connector is designed to accept 18 AWG – 12
AWG wire. To connect the remote turn-on
wire to the amplifier, first back out the set
screw on the top of the terminal block, using
the supplied 2.5mm hex wrench. Strip 1/2
inch (12mm) of wire and insert the bare wire
into the terminal block, seating it firmly so
that no bare wire is exposed. While holding
the wire in the terminal, tighten the set screw
firmly, taking care not to strip the head of the
screw and making sure that the wire (not the
insulation) is firmly gripped by the set screw.