JKEXER Turbo 772, Руководство пользователя

Страница: 18 / 24

DISTANCE:
Count up; Accumulates total working distance from 0 to 99.9KM or MILES.
Count down; Counts the preset working distance (1-20km) backwards to 0 to stop running.
PULSE:
It shows your heart beat when holding sensor plates on two handlebars.
INCLINE:
Display desired incline from 0
–
12%.
SPEED:
Display the desired running belt speed. The speed can be adjusted from Min. 0.5MPH/0.8KPH to
10MPH/16KPH by 0.1 increments by pushing SPEED UP/ DOWN buttons.
DOT MATRIX:
In manual mode: There are 40 dots on the 400 meters lap. So one dot means 10 meters. When the
machine starts, the light will jump to next one after running to10 meters.
In program mode: Each profile will appear on it for 12 programs.
PROGRAM:
1
–
12 preset program
LEVEL:
1-3 levels.
ERROR MESSAGE & TROUBLE SHOOTING
E1 (Error 1):
When the machine starts but computer could not read the signal from sensor for 7 seconds,
E1 will be shown on the computer.
E6 (Error 6):
When the machine starts but computer could not read the VR signal from incline motor for 6 seconds,
E6 will be shown on the computer.
If any above trouble happens, please consult the distributor.
E3 (Error 3):
It happens only in HRC mode (H1, H2, or H3) when user
’
s heart rate is 20 beats more than target heart rate
and last for over 30 seconds. For your safety, you should stop running when E3 appears.
SMELL
If any smell comes out from motor, please firstly spray out some silicone on the running board (Please refer
to page : RUNNING BOARD MAINTENANCE), and see if the situation improves. Then consult the distribu-
tor for necessary help.
16