JK Smart BMS JK-B1A8S20P/JK-B2A8S20P User Manual
a)
Li-ion buttion
Click this button to change all the working parameters of BMS to Li-ion parameters, and the
default values of Li-ion battery parameters are shown in the Appendix.
b)
LiFePO4 button
Click this button to modify all working parameters of BMS to LiFePO4 battery parameters,
the default values of LiFePO4 battery parameters are shown in the appendix.
c)
LTO button
Click this button can change all the working parameters of BMS to LTO parameters. The
default values of LTO battery are shown in the Appendix.
d)
Cell Count
Cell count indicates the number of cells in the current battery pack, please set the value accurately
before use, otherwise the BMS will not work properly.
e)
Battery Capacity(Ah)
This value is the design capacity of the battery.
f)
Balance Trig. Volt.(V)
With the balancing function enabled, when the maximum voltage difference of the cell pack
exceeds this value and the current cell voltage exceeds the balancing start voltage, the BMS
starts balancing the cell until the differential voltage is lower than this value or the cell voltage
is lower than the balancing start voltage. For example, if you set the balancing trigger voltage
difference to 0.01V, balancing will start when the cell pack voltage difference is greater than
0.01V and end when it is lower than 0.01V.
(It is recommended to set the balancing trigger differential to 0.005V for cells above 50AH and
0.01V for cells below 50AH).
g)
Calibrating Volt.(V)
The voltage calibration function can be used to calibrate the accuracy of the BMS voltage collection.
When you find an error between the collected voltage and the actual voltage of the battery, you can use
the voltage calibration function to calibrate the BMS.
To calibrate, fill in the current manually measured battery voltage, and then click the 'Set' button next to
Voltage Calibration to complete the calibration.
h)
Calibrating Curr.(A)
17 /22
, providing you with quality accessories for DIY batteries.
