4
AutoHybrid IP2™
VoIP/AoIP Codec
Getting Connected
Setting Up
Although each application will require a slightly different setup, following is a
general cable connection setup and explanation.
1. Connect the supplied ethernet cable between the jack marked <LAN> and
an active ethernet port.
2. Connect to your mixer.
i. Connect a line-level audio signal to the AutoHybrid IP2 <Line In> jack(s).
ii. Connect the <Line Out> jack(s) to the line-level input(s) on your
mixing console.
3. Connect the supplied AC power cord to the back of the AutoHybrid and then
to an AC power outlet. Or, enable Power over Ethernet (PoE) on your switch
or router.
Your AutoHybrid IP2 will be ready to take calls once a SIP Account is configured.
What is SIP?
Session Initiation Protocol.
It is a standard communications protocol used for controlling multimedia
communication sessions. For public service outside of your local network, users
must register with a VoIP provider which provides a directory service similar to a
public switched telephone network for POTS lines.
The AutoHybrid IP2 protocol stack provides the components necessary to
provide a standardized method for managing the device, providing real-time
multimedia transport and monitoring and controlling the Quality of Service.
SIP is a standard mechanism for connection management, including registration
and location service, that provides phone number portability across the internet.
