CK0063 - Rev 03.2
780.922.4534
jireh.com
5.
Place the wedge on the inner probe holder arm’s button and clamp in place with the outer
probe holder arm
(Fig. 4)
. Tighten the probe holder arm adjustment knob.
4.2. Encoder Setup
1.
Loosen the encoder’s thumb screw and lower the encoder wheel’s pivot joint towards the
scan surface
(Fig. 5)
.
2.
Tighten the encoder thumb screw and ensure adequate spring tension of the encoder
wheel to the scan surface
(Fig. 6)
.
5
TROUBLESHOOTING
Encoder not
incrementing
Encoder wheel not in contact with
scan surface
Rotate pivot joint until wheel is in
contact with scanning surface and
spring joint is slightly depressed.
(see 4.2. Encoder Setup)
Encoder connector not properly
connected to scanning device
Check scanning devices instructions
to properly connect an encoder.
6
SPARE PARTS
6
5
8
9
10
7
4
1
2
3
Part #
Description
1
CKA010
ODI-II Case
2
3
4
5
6
7
8
9
10
BOM ID
CKS015
Encoder Clamping Mount
CKS011-X-05 Encoder Assembly
(Various encoder connector types)
PH0082
Probe Holder Arm Adjustment Knob
CK0018
Clamp Arm
(50 mm, Various sizes available)
CKS014
Yoke Clamping Mount
PH0011-X
Pivot Button
(Various available)
PH00XX
MD050-010
Arm Clamp Screw, SHCS, M4x0.7 X 8 mm, SST
CK0047-X
Dovetail Slide Frame Bar
(30 mm, Various sizes available)
Arm Style
(Various available)
Visit jireh.com for
information
Fig. 4
- Mount wedge
Fig. 5
- Lower encoder wheel
Fig. 6
- Ensure spring tension