Jinhua Unisky Tools TY-JSU3-B, Руководство пользователя

Страница: 19 / 21

19
FAQ
About the trainer
1.Is the trainer noiseless? why sometimes it is very noisy?
A:The noise is mainly related to the materials and tread of bike tires. The use of road bikes is highly suggested
because the spinning sound will be louder and it possible to wear out the tires if mountain bike is used. We also
recommend using the bike trainer on a carpet to reduce noise.
2.Why did my bike tires go through a seriously worn?
A: The tire pressure may be too low and you should better inflate to make up the tire pressure. Check whether
the roller and the bike are too closely or loosely pressed together.
3. Why is my trainer always shaking when riding?
A: The ground is rough, or the user fail to level the bike trainer according to the instructions. Try to adjust the
adjusting feet pads. Moreover, the handle may be not locked in place and the bike is not firmly fixed, so check
the handle and all the joint areas.
About the sensor
1.Why is the sensor not discovered by other equipment when it's not used for a long time?
A: In order to save battery energy. The sensor will go to sleep when it detects no data for 90 seconds. Normal
broadcasting will resume when the device is used
2.Why doesn't the indicator light illuminate when reinstalling the battery?
A: It's possible the battery connector is covered with foreign contaminate or the spring is not pushed up.
If the connector is clean and sprung-up, replace the battery with a brand new battery. (battery model is
CR2032-3V)
If the problem is not solved, please contact online technical support.
3.Why can't the sensor be found by other equipment?
You should check:
•
Check the sensor is in the correct mode. Green: Power Trainer.
•
Whether the software is compatible.
•
Whether there are any inductive magnets causing interference.
•
If the battery is dead, replace it with a new one.
•
If the problem is not solved, please contact online technical support.
4.ls there any delay in the data of the sensor?
The trainer sensor uses geomagnetic sensor measurement data. Abandoning the traditional magnet sensing
scheme, the installation is more convenient, but there is a certain delay in calculating the data. The main
reason for data display delay is that the device uses an averaging algorithm to smooth the data.