7
290148-GB(V3)
www.jilong.com
4.Lift the stopper from the inlet & outlet port of the pool inside. Then
remove away strainers in the inlet & outlet port of the pool inside. (See
the Fig. 4)
5. Plug the Heater into the electricity outlet.
- The pump will start working while you insert the plug of the pump to
an electrifiable receptacle.
- Press the On/Off switch to set the power off, and press again to set
it on, and go on in this order.
6. Press the “ADJUST” button on the control panel of Heater to set
the heating temperature to a maximum of 40
℃
.
NOTE: The increased Heat Rate are relevant for a covered pool
with water at 25 . The actual heating time may vary according
to the pool’s water volume, environmental temperatures, desired
temperatures and other conditions.
Pool size
Water capacity
heating rate
increase by 1°C
2.4mx63cm(8'x25")
2074L(548gal
)
3.0m x 76cm (10'x30")
3518L(956gal
)
3.60m x 76cm (12'x30")
5377L(1421gal
)
3.60m x 90cm (12'x36")
6654L(1758gal
)
4.50m x 90cm (15'x36")
10175L(2688gal
)
Hours
1.0
Hours
2.3
Hours
2.8
Hours
3.5
Hours
6.5
