JF JF 40P, Руководство по эксплуатации и техническому обслуживанию

Страница: 19 / 60

19
e) Let the impeller (4) locked with a wood shim and
reinstall the knifes (1), observing the correct fastening
position:
the face with the chamfer should be
returned for the rear of the Forage Chopper,
according to picture aside.
f) VERY IMPORTANT: After to assemble and to tighten
all knives, check the gap between knifes and the
counterknife, according instructions on next item.
Chanfer
6.3- Gap adjustments between knife and counterknife
This adjustments must be done after the sharpen or
new knifes installation.
a) Remove the feeding chute (1) loosing the pin (2).
b) Loosen (but don’t remove) the impeller fastening bolts
(3).
c) Displace the impeller (4) manually forward,
approximating the knifes (5) nearest as possible against
the counter knife (6).
IMPORTANT: It cannot have interference between the
knives and counterknife during the operation. Therefore,
JF recommends a minimum gap
0,05 to 0,15 mm.
d) Check the gap through feeding nozzle (7), turning the
impeller (4) manually and slowly.
e) After the adjustment, tighten the bolts (3) to fasten the
impeller (4) on correct position.
f) Reinstall the chute (1) and close the impeller
compartment cover.
1
4
2
3
7
6
4
5
8
1
OPERATION TECHNICAL MANUAL - FORAGE CHOPPER JF 40P
E
n
g
li
s
h