JF FCT 1460, Инструкция по применению, Страница: 86 / 114

7. MAINTENANCE
PIGB-206X-02 FCT1460 0614
- 86 -
Fig. 7-4 The torque in the friction clutch is adjustable. However, you should not change the
factory-
set adjustment until you have contacted the dealer or the factory’s Service
Department.
The friction clutch has 4 different torque adjustments. The adjustment can be
changed by turning the adjustment ring
D and by choosing between 2 different
positions in the clutch housing.
1. The adjustment ring has a
minimum and a maximum position.
2. The clutch housing has two different sets of slots
E in the height into which the
adjustment ring D can be mounted, pos. 1 and pos. 2 .
TORQUE ADJUSTMENT GUIDE
PTO Torque Adjustment
1000 2700 Nm Step l
1000 3000 Nm Step II
1000 3300 Nm Step III
1000 3600 Nm Step lV
From the factory the clutch is delivered with adjustment II, corresponding to 3000 Nm
and should not be adjusted higher!
Adjustment of the torque can only be made when the nuts A (on Fig. 7-3) are
tightened. After the adjustment the nuts are loosened again to the end of the bolt.
WARNING: If the clutch is overloaded by slipping for some time, it will get
heated and thus be worn quickly.
Overheating will damage the friction plates. If the clutch is
blocked or partly put out of function in other ways, the factory
guarantee will be discontinued.
Fig. 7-4