Jevi EF Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 11 / 24

08099901
10
Damages caused by bad workmanship or failure to adhere to the installation instructions
are not covered by the equipment warranty.
If the equipment is installed in an area where ongoing construction work of a nature that
causes airborne pollution or other adverse conditions take place, the equipment must be
suitably protected
. Under no circumstances can the equipment be placed in the vicinity of
any activity, which involves grinding, welding, painting, fireproofing, spraying, etc. without
taking necessary precautions to protect it.
When cable termination is completed, a fresh desiccant bag
must be placed in the
enclosure. The desiccant bag must be replaced every 6 month or until commissioning, has
been initiated.
All openings such as cable entry holes must be adequately sealed until the interfacing
cables or pipes are installed.
During installation, always keep the equipment in a clean condition. Remove debris from
cable installation activities at once. Take precautions to avoid any small pieces of a
conductive nature from being left in the termination enclosures.
Under no circumstances may the equipment itself be used as a platform for gaining access
to installation and construction areas above. If such access is required then suitable
scaffolding must be established, the equipment may not be used as a support.
During installation the equipment must be thoroughly inspected at regular weekly intervals
with regards to external damages, cleanliness and internal condition. Report and
document immediately if any visible damage or adverse condition occurs. In case of such
an event, the supplier must be contacted immediately for advice.
On completion of the installation work the condition of the equipment must be inspected.
Report and document any damage immediately if any visible damage. In case of such an
event, the supplier must be contacted immediately for advice.
CAUTION It is extremely important that no debris enters the vessel as
this may lead to a blockage of the return, or overflow pipes
.