13
2-5-3 Interrupt Request Table For This Motherboard
Interrupt request are shared as shown the table below:
INT A
INT B
INT C
INT D
PCI slot 1
Shared
PCI slot 2
Shared
PCI slot 3
Shared
PCI slot 4
Shared
PCI slot 5
Shared
AGP slot
Shared
AC97/MC97
Shared
Onboard USB
Shared
Onboard USB 1
Shared
Onboard USB 2
Shared
IMPORTANT!
If using PCI cards on shared slots, make sure that the drivers support
“Shared IRQ” or that the cards don’t need IRQ assignments. Conflicts
will arise between the two PCI groups that will make the system
unstable or cards inoperable.
2-5-4 AGP Slot
This motherboard provides an AGP Slot, support the 1X/2X/4X/8X AGP VGA card.
AGP SLOT
2-6 Connectors, Headers
2-6-1 Connectors
(1) Power Connector (20-pin block) : ATXPOW
ATX Power Supply connector. This is a new defined 20-pins connector that usually
comes with ATX case. The ATX Power Supply allows to use soft power on
momentary switch that connect from the front panel switch to 2-pins Power On
jumper pole on the motherboard. When the power switch on the back of the ATX
power supply turned on, the full power will not come into the system board until the
front panel switch is momentarily pressed. Press this switch again will turn off the
power to the system board.
