JETWAY NF9G-QM77, Техническое руководство

Страница: 38 / 49

33
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor. The optional settings: [Auto];
[Manual].Select [Manual] you can set value for the following sub-item:
Device
Power-up delay in seconds, the delay range in from 1 to 40 seconds, in one
second increments.
►
SMART Settings
Press [Enter] to make settings for SMART Self Test. The optional settings are:
[Disabled]; [Enabled].
►
Super IO Configuration
Press [Enter] to make settings for the following sub-items:
Super IO Configuration
CIR Controller
Use this item to enable or disable CIR controller.
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
►
PC Health Status
Press [Enter] to view hardware health status.
►
SmartFan Configuration
Press [Enter] to make settings for SmartFan Configuration:
Smart Fan Configuration:
CPUFAN / SYSFAN1 Smart Mode
When set as [Enabled], the following sub-items shall appear:
CPUFAN Full Speed Temperature / SYSFAN1 Full Speed Temperature
Use this item to set CPUFAN/SYSFAN1 full speed temperature. Fan will run at full
speed when above this temperature.
CPUFAN Idle Speed Temperature / SYSFAN1 Speed Temperature
Use this item to set CPUFAN/SYSFAN1 idle speed temperature. Fan will run at
idle speed when below this temperature.
CPUFAN/SYSFAN1 Idle Speed Duty
Use this item to set specific duty at which CPUFAN/SYSFAN1 will run at idle
speed.