30
The settings specify how the host computer and the remote computer (which the
user is using) will exchange data. Both computers should have the same or
compatible settings.
Press [Enter] to make settings for the following items:
Out-of-Band Mgmt Port
Terminal Type EMS
The optional settings: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
[VT-UTF8] is the preferred terminal type for out-of-band management. The next
best choice is [VT100+] and them [VT100]. See above, in Console Redirection
Settings page, for more help with Terminal Type/Emulation.
Bits per second EMS
Use this item to select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings: [9600]; [19200]; [57600]; [115200].
Flow Control EMS
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a “stop” signal can be sent to stop the data flow.
Once the buffers are empty, a “start” signal can be sent to re-start the flow.
Hardware flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits EMS
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity EMS
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits EMS
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
Legacy USB Support
The optional settings: [Enabled]; [Disabled]; [Auto].
[
Enabled
]: To enable legacy USB support.
[
Disabled]
: to keep USB devices available only for EFI specification,
[
Auto
]: To disable legacy support if no USB devices are connected.
*
Note:
‘Legacy USB Support’
item may or may not show up, depending on
different chipset.
Q470E chipset supports this item.
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver.
The optional settings: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB mass storage driver support.
The optional settings: [Disabled]; [Enabled].
