26
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a
“stop” signal can be sent to stop the data flow.
Once the buffers are empty, a
“start” signal can be sent to re-start the flow.
Hardware flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
►
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’.
►
SmartFAN Configuration
Press [Enter] to make settings for SmartFan Configuration:
SmartFAN Configuration
CPUFAN/SYSFAN Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN/SYSFAN Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN full speed temperature. Fan will run at full
speed when above this pre-set temperature.
CPUFAN/SYSFAN Full-Speed Duty
Use this item to set CPUFAN/SYSFAN full-speed duty. Fan will run at full speed
when above this pre-set duty.
