12
WARNING! For the SDR SDRAM CLOCK is set at 133MHz, use only PC133-
compliant SDR Modules. When this motherboard operate at 133Mhz,
most system will not even boot if non-compliant modules are used because
of the strict timing issues, if your SDR Modules are not PC133-compliant,
set the SDR SDRAM clock to 100MHz to ensure system stability.
2-5 Expansion Cards
WARNING! Turn off your power when adding or removing expansion cards or other
system components. Failure to do so may cause severe damage to both
your motherboard and expansion cards.
2-5-1 Procedure For Expansion Card Installation
1. Read the documentation for your expansion card and make any necessary
hardware or software setting for your expansion card such as jumpers.
2. Remove your computer’s cover and the bracket plate on the slot you intend to
use.
3. Align the card’s connectors and press firmly.
4. Secure the card on the slot with the screen you remove above.
5. Replace the computer system’s cover.
6. Set up the BIOS if necessary.
7. Install the necessary software driver for your expansion card.
2-5-2 Assigning IRQs For Expansion Card
Some expansion cards need an IRQ to operate. Generally, an IRQ must exclusively
assign to one use. In a standard design, there are 16 IRQs available but most of
them are already in use.
Standard Interrupt Assignments
IRQ Priority
Standard
function
0 N/A
System
Timer
1 N/A
Keyboard
Controller
2 N/A
Programmable
Interrupt
3 *
8
Communications Port (COM2)
4 *
9
Communications Port (COM1)
5 *
6
Sound Card (sometimes LPT2)
6 *
11
Floppy Disk Controller
