29
Device Settings
Change Settings
Use this item to select an optimal setting for Super IO Device.
The optional settings: [IO=2F8h; IRQ=10;]; [IO=3F8h; IRQ=3,4,5,7,10,11;];
[IO=2F8h; IRQ=3,4,5,7,10,11;]; [IO=3E8h; IRQ=3,4,5,7,10,11;]; [IO=2E8h;
IRQ=3,4,5,7,10,11;]; [IO=3E0h; IRQ=3,4,5,7,10,11;]; [IO=2E0h;
IRQ=3,4,5,7,10,11;].
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
The optional settings: [Disabled]; [Enabled].
When set as
[Enabled]
, the following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [4] to [255] seconds when ‘WatchDog
Reset Timer Unit’ set as [Sec]; or in the range of [4] to [255] minutes when
‘WatchDog Reset Timer Unit’ set as [Min].
WatchDog Reset Timer Unit
The optional settings: [Sec.]; [Min.].
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (
refer to
CASE
jumper setting for Case Open Detection
); if Pin 1&2 of
CASE
are short,
system will show Case Open Message during POST.
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’ and set value in ‘
Shutdown Temperature
’.
►
SmartFAN Configuration
Press [Enter] to make settings for ‘
SmartFan Configuration
’:
SmartFAN Configuration
CPUFAN Smart Mode
The optional settings: [Disabled]; [Enabled].
When set as
[Enabled]
, the following sub-items shall appear:
