26
Press [Enter] to make settings for the following sub-items:
SATA Configuration
SATA
Port
Use this item to enable or disable SATA Port.
The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
PCH-FW Configuration
Press [Enter] to view Management Engine Technology Parameters and make
settings in the following sub-item:
ME Firmware Version
ME Firmware Mode
TPM Device Selection
Use this item to select TPM Device.
The optional settings: [dTPM]; [PTT].
[PTT]
: Enable PTT in SkuMgr;
[dTPM]
: Disable PTT in SkuMgr.
Warning!
PTT/dTPM will be disabled and all data saved on it will be lost.
Firmware Update Configuration
Press [Enter] to make settings for ‘
Me FW Image Re-Flash
’.
Me FW Image Re-Flash
Use this item to enable or disable Me FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
*
Note
:
In the case that user needs to update Me firmware, user should set
‘Me
FW Image Re-Flash
’ as [
Enabled
], save the settings and exit. The system will
turn off and reboot after 4 seconds. If the user goes to BIOS screen again will find
this item is set again as [
Disabled
], but user can still re-flash to update firmware
next time.
Trusted Computing
Press [Enter] to view current status information, or make further settings in the
following sub-items:
Configuration
Security Device Support
Use this item to enable or disable BIOS support for security device. O.S. will not
show Security Device. TCG EFI protocol and INT1A interface will not be available.
The optional settings: [Disabled]; [Enabled].
ACPI Settings
Press [Enter] to make settings for the following sub-items:
ACPI Settings
ACPI Sleep State
Use this item to select the highest ACPI sleep state the system will enter when the
SUSPEND button is pressed.
The optional settings: [Suspend Disabled]; [S3 (Suspend to RAM)].
Wake-up Function Settings
Press [Enter] to make settings for the following sub-items:
Wake-up System With Fixed Time
