21
[Auto]: Initializes to deepest available Package C State Limit.
►
SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], user can make further settings in the following items:
SATA Mode Selection
The optional setting is: [AHCI].
SATA
Port
Use this item to enable or disable device connected respective port.
The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
mSATA
Port
Use this item to enable or disable device connected to MSATA port.
The optional settings: [Disabled]; [Enabled].
►
PCH-FW Configuration
Press [Enter] to view ME information and make settings in the following sub-items:
TPM Device Selection
Use this item to select TPM device.
The optional settings: [dTPM]; [PPT].
Warning!! PTT/dTPM will be disabled and all data saved on it will be lost.
►
Firmware Update Configuration
Use this item to configure Management Engine Technology parameters.
Press [Enter] to make settings for
‘
ME FW Image RE-Flash
’
.
ME FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
* In the case that user needs to update ME firmware, user should set
‘
ME FW
Image Re-Flash
’
as [Enabled], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this item
is set again as [Disabled], but user can still re-flash to update firmware next time.
►
AMT Configuration
Press [Enter] to configure Intel (R) Active Management Technology parameters.
Intel AMT
The optional settings: [Disabled]; [Enabled].
When set as [Disabled] AMT BIOS features are no longer supported and user is
no longer able to access MEBx setup. This option does not disable Manageability
Features in FW.
When set as [Enabled], user can make further settings in the following items that
show up:
Hide Un-Configure ME Confirmation Prompt
Use this item to hide un-configure ME confirmation prompt when attempting ME
un-configuration.
