24
Suspend Type:
Select the Suspend Type.
The choice: PWRON Suspend, Stop Grant.
MODEM Use IRQ:
This determines the IRQ in which the MODEM can use.
The choice: 3, 4, 5, 7, 9, 10, 11, NA.
Suspend Mode:
When enabled and after the set time of system inactivity, all devices
except the CPU will be shut off.
The choice: Enabled, Disabled.
HDD Power Down:
When enabled and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
The choice: Enabled, Disabled.
Soft-Off by PWRBTN:
Pressing the power button for more than 4 seconds forces the
system to enter the Soft-Off state when the system has “hung.”
The choice: Delay 4 Sec, Instant-Off.
Power on by ring :
When you select
Enabled,
a signal from ring returns the system to Full On
state.
Resume on by alarm :
When you select
Enabled,
the system will wake up from suspend mode as
defined in Resume Time.
The choice: Enabled, Disabled.
3-6 PnP/PCI CONFIGURATION SETUP
This section describes configuring the PCI bus system. PCI, or
P
ersonal
C
omputer
I
nterconnect, is a
system which allows I/O devices to operate at speeds nearing the speed the CPU itself uses when
communicating with its own special components. This section covers some very technical items and it is
strongly recommended that only experienced users should make any changes to the default settings.
CMOS Setup Utility – Copyright © 1984-1999 Award Software
PnP/PCI Configurations
PNP OS Installed NO
Reset Configuration Data Disabled
Resources Controlled By Manual
¾
IRQ Resources
Press Enter
¾
DMA Resources Press Enter
PCI/VGA Palette Snoop
Disabled
Assign IRQ For VGA
Enabled
Assign IRQ For USB
Enabled
Item Help
Menu Level
¾
Select Yes if you are using
A Plug and Play capable
operating system Select
No if you need the BIOS to
Configure non-boot devices
↑↓←→
Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Figure 3-6
PnP OS Installed:
This item allows you to determine installed PnP OS or not.
The choice: Yes, No.
Reset Configuration Data:
Normally, you leave this field Disabled. Select Enabled to reset
Extended System Configuration Data (ESCD) when you exit Setup if you have installed a
new add-on and the system reconfiguration has caused such a serious conflict that the
operating system can not boot.
The choice: Enabled, Disabled .
Resource controlled by:
Auto will allow the Award Plug and Play BIOS to automatically
configure all of the boot and Plug and Play compatible devices. If you have trouble in