13
CO
M2
Floppy drive Connector
Pin 1
7. Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the single
plug end to mainboard, connect the two plugs at other end to your hard disk(s). If you install
two hard disks, you must configure the second drive to Slave mode by setting its jumpers
accordingly. Please refer to the documentation of your hard disk for the jumper settings.
CO
M2
Secondary IDE Connector
Pin 1
8. Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the same
procedure described for the primary IDE connector. You may also configure two hard disks
to be both Masters using one ribbon cable on the primary IDE connector and another ribbon
cable on the secondary IDE connector.
CO
M2
Secondary IDE Connector
Pin 1
9. IDE activity LED: HDLED
This connector connects to the hard disk activity indicator light on the case.
CO
M2
IDE (Hard Drive) LED
HDLED
10. SMI Switch : SMI
If your case has Suspend switch , you may connect the cable to this connector in order to
have Suspend mode control from your case.
