11
2-5-4 AGP Slot
This motherboard provides an AGP Slot, only support the TV-out/DVI card.
Do not use AGP 2X card in this motherboard. It will burn and damage the motherboard
due to Intel® 845GV chipset can not support AGP VGA card.
The AGP Slot only supports AGP Digital Display Card for digital display and TV-out.
Do not Plug-in and AGP VGA card in this slot, because the Intel 845GV chip set did not
support AGP slot, this slot only support TV-out/DVI card which follow Intel AGP Digital
Display Interface standard.
AGP SLOT
Example 1:
SiS 305 & ATi Rage 128 Pro AGP card those golden finger is compatible with
2X/4X mode AGP slot, but only can support 2X (3.3V) only. If you install these
cards in Intel® 845 based motherboard it will burn and damage the motherboard.
Example 2:
We also find Diamond Vipper V770 golden finger is design for 2X/4X mode
AGP Slot. It can be adjusted the jumper for AGP 2X (3.3V) or AGP 4X (1.5V).
But the factory default setting is 2X (3.3V). If you install this AGP card in
motherboard without change the jumper setting to 4X (1.5V), it will burn the
motherboard.
2-6 Connectors, Headers
2-6-1 Connectors
(1) Power Connector (20-pin block) : ATXPWR
ATX Power Supply connector. This is a new defined 20-pins connector that usually comes
with ATX case. The ATX Power Supply allows to use soft power on momentary switch that
connect from the front panel switch to 2-pins Power On jumper pole on the motherboard.
When the power switch on the back of the ATX power supply turned on, the full power will
not come into the system board until the front panel switch is momentarily pressed. Press
this switch again will turn off the power to the system board.
PIN
ROW2
ROW1
1 3.3V
3.3V
2 -12V
3.3V
3 GND
GND
4 Soft Power On
5V
5 GND
GND
6 GND
5V
7 GND
GND
8 -5V
Power OK
9 +5V
+5V (for Soft Logic)
10 +5V
+12V
Pin 1
2x notch 4x notch