28
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write.
If your IDE hard drive supports block mode (most new drives do), select Enabled for
automatic detection of the optimal number of block read/writes per sector the drive can
support. The settings are: Enabled, Disabled.
3-7-2 OnChip Device Function
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
OnChip Device Function
Item Help
USB Controller Enabled
USB Keyboard Legacy Support Disabled
1394 Controller Enabled
ETHERNET Function Enabled
ETHERNET Address IDE Input Press Enter
Current ETHERNET Address is 003018-XXXXXX
Menu Level >>
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
USB Controller
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller and you
have a USB peripherals. The settings are: Enabled, Disabled.
USB Keyboard Legacy Support
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller and you
have a USB keyboard. The settings are: Enabled, Disabled.
ETHERNET Address ID Input
This item allows you to setting the Mac address from 000000 to FFFFFF.
3-7-3 Onboard SuperIO Function
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
Onboard SuperIO Function
Item Help
Onboard FDD Controller Enabled
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART2 Mode Normal
IR Duplex Mode Half
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
ECP Mode Use DMA 3
Menu Level >>
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
