6
TYPHOON HOT G2 MANUAL - WATER JETTER/DRAIN CLEANER
The manufacture reserves the right to modify design features and technical facts without notice: due to our principals of continuous improvement.
Figure.4B - Typhoon Hot G2 Water Filter
The machine serial number is located on the frame. The
first letter & digits indicate the year and month of the
manufacture. (G = 2021 (Year), 4 = April (Month)).
NOTICE This machine is made to clean drains. If properly
used it should not damage a drain that is in good condition
and properly designed, constructed and maintained.
If the drain is in poor condition or not properly designed,
constructed or maintained, the drain cleaning process
may not be effective or could cause damage to the drain.
The best way to determine the condition of a drain before
cleaning is through visual inspection with a camera.
Improper use of this jetting machine can damage the jetter
and the drain. This machine may not clear all blockages.
Machine Assembly
WARNING
To prevent serious injury during use and prevent
machine damage, follow these procedures for proper
assembly.
Engine Oil
NOTICE The unit is shipped with oil in the engine.
Operating the engine with low or no oil will result in engine
failure. See supplied engine operator’s manual for specific
information on checking oil, adding oil and oil selection.
Pump/Gearbox Oil
The unit is shipped with oil in the pump and gearbox.
Check oil level (ensure half way on sight-glasses) per
Maintenance section.
Wheels (Optional)
Typically the unit is boxed and shipped with wheels
assembled. Wheels, Axles & Locking Collar are found
within the box. To assemble the wheels, slide axles through
axle location hole, slide wheels on each side find centerline
and proceed to install locking collar each side with 4mm
Allen key tool. (if applicable)
Pre-Operation Inspection
WARNING
Before each use, inspect your pressure cleaner and
correct any problems to reduce the risk of serious
injury from high pressure water and other causes and
prevent unit damage. Always wear appropriate safety
equipment, when inspecting your unit.
1. Make sure that the battery isolator (if applicable) and
engine switch is in the OFF position.
2. Clean any oil, grease or dirt from the equipment,
including the handles and controls. This aids inspection
and helps prevent the machine or control from slipping
from your grip.
3. Inspect the high pressure cleaner and accessories for
the following:
• Proper assembly and completeness.
• Broken, worn, missing, misaligned, binding or loose
parts.
• Presence and readability of the warning labels.
(See Figure 4A.)
• Any other condition which may prevent the safe
and normal operation.
If any problems are found, do not use the unit until the
problems are corrected.
Figure.4A - Typhoon Hot G2 Warning Labels
Clean water filter (Figure 4B). Unscrew the clear plastic
bowl cover anti-clockwise and remove and clean the mesh
filter (note: ensure the o-ring is set back into place before
screwing plastic bowl back on). Dirt and debris can restrict
the water flow to the pump and cause performance issues.
