15
TYPHOON HOT G2 MANUAL - WATER JETTER/DRAIN CLEANER
The manufacture reserves the right to modify design features and technical facts without notice: due to our principals of continuous improvement.
Figure.16 - Checking Pump and Gearbox Oil Level
Change oil in pump after first 50 hours of operation and
every 250 hours of operation after that. With the pump
warm from operation, remove plug on bottom of pump
and drain oil into suitable container. Replace plug. Fill to
approximately half-way on the sight-glass with SAE 15W-
40 Mineral non-detergent oil using the checking procedure.
Approximately 1000 ml of oil are required to change the
pump oil.
At 1000 hours of use (less in severe use conditions)
the Typhoon Hot G2 should be taken to a Jetwave
Independent Service Center for pump seal and valve
service.
Gearbox Lubrication
Check the gearbox oil level prior to each use. Place the
jetter on a level surface. Wipe any dirt and debris from
the area of the dipstick and sight-glass (Figure 16). Oil
level should be at the middle of the sight-glass. If needed,
remove the dipstick and add SAE 85W-140 gear lubricant
oil, fill to half-way on the sight-glass. Do not overfill, reinstall
dipstick.
Change oil in gearbox every 500 hours of operation. With
the gearbox warm from operation, remove plug on bottom
of gearbox and drain oil into suitable container. Replace
plug. Fill to half-way on the sight-glass with SAE 85W-140
gear lubricant oil. Approximately 300 ml of oil are required
to change the gearbox oil.
Preparing Pump for Cold Weather
Storage
If the jetter will be stored under conditions where the
temperature is near or below 0°C, the jetter must be
properly prepared. If water freezes in the pump, it can
damage it.
After the tank is drained, remove the hose from the
water inlet filter. Open all valves in the system and use
compressed air to force any water out of the system. This
can also be used to remove water from the hoses.
Service And Repair
WARNING
Improper service or repair can make machine unsafe
to operate.
The “Maintenance Instructions” will take care of most
of the service needs of this machine. Any problems not
addressed by this section should only be handled by an
authorized Jetwave service technician.
Water jetter should be taken to a Jetwave Independent
Service Center or returned to the factory.
For information on your nearest Jetwave Independent
Service Center or any service or repair questions:
• Contact your local Jetwave distributor.
• Visit jetwavegroup.com.au/find-a-dealer/ to find your
local Jetwave contact point.
• Contact Jetwave Technical Service Department at
[email protected] or call (08) 8371 3599
Disposal
Parts of the water jetter contain valuable materials and
can be recycled. There are companies that specialize
in recycling that may be found locally. Dispose of the
components in compliance with all applicable regulations.
Contact your local waste management authority for more
information.
PUMP OIL SIGHT GLASS
GEARBOX OIL SIGHT GLASS
Machine Storage
Store the jetter in a well ventilated area protected from rain
and snow. Keep the machine in a locked area that is out
of reach of children and people unfamiliar with Jetters. This
machine can cause serious injury in the hands of untrained
users. See Maintenance section for information on cold
weather storage. See engine operator’s manual for specific
information on engine storage.
