11
2
ASSEMBLY
2.1 Suggestions for assembly
Installing the wall fittings in concrete shuttered pools
•
Assembly (see picture 1)
Position the suction wall niche into the concrete shuttered pool in such a way that the read label „oben“
is on top and the plug “2” is at the bottom.
The flange of the LARGO or PUNTO shower piece wall fitting must be set flush with the concrete shuttered pool (see picture 2).
Position the pneumatic switch wall niche into the concrete shuttered pool as per picture 1.
In the case of a liner / concrete pool, the wall niche may project in order to compensate for the cement render or liner insulation
thickness. It is advisable to make provision for protecting tube by placing it in a protective conduit or through adjacent cable /
ventilation ducts. Remove protective covers only before tiling.
•
Tile plan (see picture 3)
Render and tile to inner edge of wall fittings.
•
Steel, aluminium and polyester pools (see pictures 4, 5 and 6)
Position rubber gaskets, screws and clamping frames as shown in picture 4.
Installation Suggestion
1
3
4
sunk screw M6 x 30
Flachkopf-
schraube M5
24
24
10,2
beton
stopper 2“
2
wall duct
flange with threaded bushes
5
suction housing
protection
tube
In case of a concrete wall thickness of more
than 24 cm, unscrew the protection pipe and
use the enclosed protection tube
24 max
45°
22,5°
15
17
8x
4
5
°-
3
6
0
22,5°
22,5°
26
M 6
M 5
10-35
Ø 0,7
8,6
6
x6
0°
= 360
10,2
gasket
screw 6 x 30
clamping frame
Shuttering
Protective sleeve for pneumatic
tube Wall thickness 24 -100 cm
Pneumatics
switch housing
Shuttering
screw
If required
M 6x35
suction
housing
render and tile
to inner edge
max thickness
render and tile
poll wall
clamping
frame
Shuttering
one rubber
gasket to front
and back of liner
dimensions in cm
water level
countersunk screw M5
pool wall
use clamping frame for
cutting and drilling
stopper 2“
d
rilling
suction pipe
intake screen
dimensions in cm
clamping frame
screw M 6
gasket
