Pull the inner rail out and slide the intermediate member back.
Install the inner rail onto the chassis.
Insert the chassis to complete the installation.
Rear Bracket
Front Bracket
Note : Please repeat the installation steps for the other side.
Install the Tray with the Disk Drive into the System Chassis
- Users must open the carrier handle of a drive tray before installing it into the empty bay of the system chassis.
- The following is the procedure for installing a disk drive with the tray into the system for both LFF and SFF disk drive trays:
1. Align a disk drive with the tray to the empty bay you would like to install and then push it all the way into the disk drive bay until the carrier
handle can be closed.
2. Lock the release button lock by pushing the lock from right to left.
- Refer to the label on the system chassis for disk drive numbering. The disk drive numbering for 2U 26-bay system will be printed on the chassis.
Release Button Lock
Release Button Lock
1
1
2
2
1
2
4
Install the outer rail / bracket assembly to the frame.
3
Step 1. Pull the middle rail fully extended in locked position.
Step 2. Ensure ball bearing retainer is located at the front of the middle rail.
Step 3. Insert chassis into middle-outer rail.
Step 4. When hit the stop, pull / push release tab to unlock and retract chassis into rack.
Step 5. Use M5x20 screws to fasten the chassis ear.
3
INSTALL THE OPTIONAL RAIL KIT
The rail kit is an optional accessory for
JetStor
J
X JBOD
series product. If you have ordered the rail kit, Please follow the racking instructions below.
CAUTION:
The populated
JetStor
J
X JBOD
system can be very heavy, to avoid any potential injury or harm to installers, or damage to
the system, we strongly recommend at least two certified operators or engineers perform the system installation.
TIP:
Please wait for the controller status LED to turn green on the rear of the chassis before attempting to discover or manage the storage
system. It may take a few seconds to boot the
J
X JBOD
system.
4
POWER ON THE STORAGE SYSTEM
Connect the Power Cables
1. Connect power cables from each power supply module to a power source.
2. Make sure to secure the power cables to the power supply modules so they cannot be pulled out accidentally.
Power on the System Components
1.
Power on the
J
X JBOD
system by pressing the power button on the front of the system.
Power Cord
Conncctor (left)
Power Cord
Conncctor(right)
