VT80BL Instruction Manual
Page 10
JETS MUNT S.L
Aligning transmitter with ecu
As the display does not photograph well we have reproduced
the display readings as a green box.
Turn on the transmitter and receiver. The opening screen should
show as (1):
Note there are four buttons on the display, two on the left and
two on the right hand side. The left buttons move to the different
screens and the right buttons are used to change the values
stored. Press the second, left button and scroll through the
menus until you find the one showing (2):
Press the (-) button and the ecu will show the “Radio”
parameters menus. First screen show graphically the current
adjusts on the radio. Press the (-) button again to enter in the
menus to adjust the radio (3).
Press the right hand button (+) to confirm that you really want to
program the radio. The screen will change to (4):
On your transmitter, raise first the trim to full and next the
throttle stick to full, in this order. Ensure stick is firmly against the
stop. Now holding the stick against the stop, press the right
button (+) to store the signal from your TX into the ECU. The
screen will now change to (5):
Move the trim (or switch the “engine cut” switch to on) and
throttle stick back to zero and again press the right hand button
(+). The display will now change to (6):
Leaving the throttle stick in the minimum position, raise the
throttle trim to the full up position or switch “Engine Cut” switch to
off, and again press the “+” button to store the value into the ecu.
If you have done all steps correctly the LED located directly
above the throttle socket in the ecu will light up flashing 2 times in
the ECU when the “Idle” command is received, meaning that trim and throttle stick are set to
idle positions on the transmitter. If the ecu battery is connected, a sound will be heard at
same rate as the Led blinks. Lower your throttle trim and the LED will change to a single
flash sequence indicating
correct reading of the transmitter engine shut off signal by the ecu.
On some Futaba transmitters, it has been found that the throttle channel the sense of
movement may require reversing (Servo reverse) and repeat the transmitter alignment.
Correct reading of throttle % by the ecu can be verified in the second screen of the data
terminal (7), percentage of the throttle position is shown on, 0% in the position of engine stop
(trim and stick down), 100% with stick/trim full up and between 10% and 30% at idle.
This now completes your radio setup and should only need doing again if the radio settings
are changed.
Trim Low T=020ºC
RPM 00000 PW 000
Info Run
Start Radio
Transmitter yes
adjust
Stick Up Trim Up
(Full power) Ok
Stick Down
Trim Down (Stop) Ok
Stick Down
Trim Up (Idle)
Pulse=1000uS 0%
Battery: 7,2V
(1)
(2)
(3)
(4)
(5)
(6)
(7)
