Jetline CWF-50A, Руководство по эксплуатации

Страница: 9 / 27

-4-
Section II Introduction
The cold wire feeder is designed to supply filler metal to the weld puddle in a mechanized
tungsten arc welding or plasma arc welding application. The system will accurately feed
0.020”, 0.030”, 0.035”, 0.045”, 0.062” and 0.093” (0.5 to 2.4 mm) hard and soft wires for
mechanized TIG or plasma welding.
The wire feeder can be mounted as an assembly or the components can be removed from
the mounting plate and installed in a number of positions with respect to each other.
The system consists of a 9700W control, D.C. motor-driven four feed roll assembly, spool
adapter, and a wire guide positioner. The positioner incorporates X-Y-Z movements of the
wire tip. The positioner includes a universal torch mounting bracket.
The basic components of the wire feeder are:
(See Figure 1)
1. Wire drive unit: consists of motor, drive housing, and wire spool assembly to feed
wire. (Part number CWF-50-DA.)
2. 9700W Control: includes a keypad, display, encoder control knob, and start/ stop
switches. The SCR motor controller is built into the control box and provides a wire feed
speed of 4 to 200 IPM (10 to 508 CPM) with a speed holding accuracy of +1% of base
speed.
For operating details and function of controls, see 9700W Operation Manual.
3. WGP-1 Wire Guide Positioner: guides wire into puddle.
Note: The wire guide positioner can be used either as a left hand or right hand assembly.
To change configuration as supplied by factory, reverse thumb knob, set screw, and spring.
(See WGP-1 drawing. item numbers 13, 18, and 24.)
4. Spool adapter: holds 12” (305 mm) diameter wire spools.
5. Wire Feed Accessory Kit: conduit, feed rolls, inlet guides, outlet guides, and tips for
0.020”, 0.030”, 0.035”, 0.045”, 0.062” and 0.093” (0.5 to 2.4 mm) hard and soft wire. Order
kits separately for desired wire size.