Manual: Speed Sensor MSPEED
-7-
4.4
Alarms
MSPEED MENU:
ALARMS
– By pressing the Down arrow, we can access the alarm settings
menu for the speed sensor. Should an alarm condition be reached, the 2nd line of the Jeti Box
(If connected) will indicate the condition and the transmitter module will emit an audible alarm
according to the morse code character specified in the main settings.
High speed Al.
– The speed which if exceeded, will raise an alarm condition.
Low speed Al.
– The speed below which an alarm condition should be raised.
5.
Installation
The main MSPEED sensor unit can be placed directly in the fuselage or installed in the wings. Please
avoid direct contact of heat sources, such as batteries, controllers and regulators. The pitot tube must
be installed outside zones of airflow directly behind propellers. As an example, the pitot tube may be
installed on the wing of a single-engined model aeroplane, or on the fuselage of a twin-engined
model.
In single engined models, it is advantageous to install the pitot tube at the leading edge of the wing at
the chord. In twin or multi-engined models, it is best to install the pitot tube in the nose of the model
or at a minimum distance of 2cm from the fuselage side.