Manual: Speed Sensor MSPEED
-6-
level is indicated with long notes and the number of tones in this case determines the shortfall
of speed. These sounds can be disabled in the
Settings
Control signal
option menu.
CONTROL SIGNAL
– By pressing the Down key, we can modify options relating to the
input control signal. This allows simple switching on/off of the audible alarms generated by
MSPEED.
Trigger level
– Set the trigger speed for recording of data. For example if
the trigger level is 1.50ms and Reverse is OFF, as soon as a speed of
1.50ms is exceeded, then data recording begins and any previously
recorded maximum/minimum values are deleted. If the speed is less than
the trigger level, no data is recorded and previously recorded data remains
unaffected. No acoustic signalling will be given in this case.
If the option SETTING
SPEED MONITOR
BEEP OF SPEED is set
to „ON“ and the control wire is not connected, then the acoustic signal will
be switched on permanently.
Revese
– Reverse the control signal input.
MAIN
– By pressing the down arrow of the Jeti Box, the main menu for MSPEED is
displayed, where the units of speed and alarm signal can be programmed.
Speed unit
– Specify the unit of measurement for speed, as one of:
km/h – Kilometres per hour
m/s – Metres per second
mph – Miles per hour
Beep speed Alarm
- Set the more code letter to be represented by the Duplex
transmitter module, should the speed sensor signal an alarm condition.