JETI model duplex DS-16 II, Руководство пользователя

Страница: 67 / 72

computer radio control system
EN
10. Do not point the transmitter antenna directly towards your
model or a human body. The radiation pattern from the antenna will
be shielded and provide poor connection to your model.
11. Never repair, re-install, or exchange the internal memory SD
card for other type.
12. Avoid extreme temperatures as they can cause damage to the
sensitive internal SD card.
13. Always perform a ground range check prior to your initial flight.
11.3 Flight Safety Check
1. Always verify the correct position of the switches, and the
gimbals, prior turning ON your transmitter. Turn on the transmitter
first, then receiver. JETI transmitters use
"Model Checking". This
safety is designed so that the model memory stores the unique serial
number of the receiver that has already been assigned to model.
When the transmitter establishes communication with the receiver
and the serial number does not match the number stored in the
current model’s setup, the transmitter displays a warning. You will
then be able to accept the change or reject the change. If you accept
the change, the transmitter stores the new receiver number into the
model’s setup and begins transmitting. If you reject the change, the
transmitter will not communicate with the receiver and you will be
allowed to select another model.
2. Perform a ground range check before each day’s flying session.
3. Check the battery voltage on both the transmitter and the
receiver battery packs.
4. Check all channel assignments, trim, mixes, and the correct
This product may be used for model airplane or surface (boat, car,
robot) use only. It is not intended for use in any other application
than control of the models for hobby, sport and recreational
purposes.
11.4 Application
direction of movement for your flight surfaces.
5. Set motor/engine kill switch and test the power train.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
11.5 FCC /IC information
67