JETI model duplex DS-16 II, Руководство пользователя

Страница: 34 / 72

computer radio control system
EN
4. Disconnect the flat flexible cable from its connector on the
main board.
The flat flexible cables that link the main printed circuit board
with the switches are oriented as shown in the picture (4a) .
The wire is always color coded on one side of both ends (4b) .
The markings must be oriented as shown below.
4.4.2 Assembly Procedure
1. Insert the flat flexible cable to the switch connector of the
switch. See the orientation above.
2. Push the switch into its spot in the transmitter housing.
3. Tighten the switch installation nut from the front of the
transmitter. Use the specialized wrench (not included).
4. Connect the flat flexible cable to the main printed circuit board
of the transmitter. See the orientation above. The cable has to
be inserted to the connector that matches the position on the front
panel where the switch is installed.
5. Reconnect transmitter battery pack and reinstall radio back
cover and cover screws.
When replacing the switch it is also necessary to Sa
remove the switches and from the transmitter Sb Sc
body.
When replacing the switch
it is also necessary to Sc
remove the switch from the transmitter body. Sb
When replacing the switch it is also necessary to Sh
remove the switches and Sf from the transmitter Sg
body.
When replacing the switch
it is also necessary to Sf
remove the switch from the transmitter body. Sg
Note:
After you turn on the transmitter for the first time after any switches
have been modified, you will notice that the configuration for a
selected model no longer matches.
4b
4a
4b
34