JETI model DUPLEX DC-24, Руководство пользователя, Страница: 136 / 168

computer radio control system EN
PPM Output Connector):
- Off – the connector output (pin No. 4) will not generate any kind of
signal.
- PPM Positive – the connector output (pin No. 4) will generate
standard eight-channel PPM signal with positive pulses.
- PPM Negative – the connector output (pin No. 4) will generate
inverted eight-channel PPM signal with negative pulses (0V level).
- EX Data Stream – the connector output (pin No. 4) will generate a
digital data stream containing EX telemetry. The format of
transmitted sensor/receiver data is described in the document JETI
Telemetry Communication Protocol. The communication is
unidirectional and cannot be used to configure the transmitter or
any linked device. If you connect the RCDroidBox device to the
transmitter, you will need to set this option.
- PPM16 Positive – the connector output (pin No. 4) will generate
16-channel PPM signal. This is suitable for use with specific sorts of
external RF modules.
14. PPM Jack function
This option presents the possibility to configure the external Jack
connector located in the antenna mount (MONO plug type should
be used):
- Off – the connector output will not generate any kind of signal.
- PPM Positive – the connector output will generate standard eight-
channel PPM signal with positive pulses.
- PPM Negative – the connector output will generate inverted
eight-channel PPM signal with negative pulses (0V level).
- PPM16 Positive - this setting can be used in connection with
several external wireless modules that require 16 channels.
4. 4.
15. Check S ignal B efore F light
It is possible to check the signal strength immediately after the
model is turned on and connected to the transmitter. If you set Yes
for this option, a warning message is generated for antenna signal
levels less than 8. To make this function work correctly, you should be
located a distance of up to several meters from the model at the
moment of switching it on. If the message is still present, please
perform a range test and check the installation of the on-board
electronic equipment.
16. Vibration Intensity
It is possible to specify the stick vibration intensity for both left and
right unit separately. The intensity can be specified in 3 steps (low,
medium, high).
134