:ON Turb Ctrl ON
Aux channel enabled for speed limiter functions and/or
Smoker.
Turbine control enabled.
:ON Turb Ctrl OFF Aux channel enabled for speed limiter functions and/or
Smoker.
Turbine control disabled. You still need to use the AUX
channel for speed limiter and/or smoker functions but the
turbine control will be in Single Channel Mode.
:Not Used
Single Channel Mode.
Totally disable the AUX channel input for engine control,
speed sensor and smoker functions. AUX channel wire does
not need to be connected to the receiver in this mode. If Not
Used is selected and you have a speed sensor, the
Maximum Limit Speed is still active, limiting the maximum
speed your plane will fly. You cannot disable this safety
function.
Single Channel Mode start/stop procedure.
•
To start the turbine, place the throttle stick and trim to there minimum positions.
Next, move the trim to its maximum position. This will initiate the LED chase.
Finally, move the throttle stick to its maximum position and the engine will start.
To stop the startup, move the throttle stick and trim to their minimum positions.
•
To stop the engine after it is running, throttle up just above idle and let it stabilize
for a couple of seconds, then move the throttle stick and throttle trim to there
minimum position. The auto-cool down mode will start when the engine has
nearly stopped rotating.
Page 32/74
