Jet SLT-660F, Инструкция по эксплуатации и каталог запасных частей

Страница: 4 / 16

4
Assembly
Note: The SLT-660F does not require any
assembly.
1. On the SLT-1650, attach the handle (A, Figure
1) to the frame using two hex cap screws, two
lock washers, two flat washers. Tighten with a
19mm wrench.
Note: The two pivoting casters can be locked
so that they do not rotate. Press foot lever (B,
Figure 1 for SLT-1650) down to lock. Press
foot lever (A, Figure 2 for SLT-660F) down to
lock.
2. Attach foot lever (A, Figure 3) to the lever
bracket (B, Figure 3) with one hex cap bolt,
one flat washer, one lock washer (C, Figure 3).
Tighten with a 14mm wrench.
Keep hands and feet clear of
table and scissor lift openings while
lowering load. Failure to comply may cause
serious injury!
3. Pump the foot lever several cycles so that the
table is out of your way while attaching the
cable.
Note: Place a 2” x 4” board straight up and
down between the table and frame so that the
table cannot come down on you while
attaching the cable.
4. Route the cable (A, Figure 4) into the cable nut
(B, Figure 4). Run the cable through the
lowering mechanism (C, Figure 4) and pull the
cable tight. Tighten the hex nut (D, Figure 4)
using a 14mm wrench.
Note: You may have to turn the hex socket
cap screw to line up the hole. This will allow
the cable to pass through freely.
Figure 4
Figure 1
Figure 2
Figure 3