Jet JWL-1840EVS, Инструкция по эксплуатации и каталог запасных частей

Страница: 3 / 36

3
27. Use the correct cutting tool for the operation to
be performed and keep all tools sharp.
28. Use low speeds for roughing and for long or
large diameter work. If vibration occurs, stop
the machine and correct the cause.
29. When sanding, remove the tool rest from the
machine, apply light pressure and use a slow
speed to avoid heat buildup.
30. When turning large diameter pieces, such as
bowls, always operate the lathe at low speeds.
See speed recommendation chart in
sect.
12.0.
31. Do not attempt to engage the spindle lock pin
until the spindle has stopped. If leaving the
machine area, turn lathe off and wait until the
spindle stops rotating before departing.
32. Make no adjustments except speed changes
with the spindle rotating, and always
disconnect the machine from the power source
when performing maintenance to avoid
accidental starting or electrical shock.
33. Provide for adequate space surrounding work
area and non-glare, overhead lighting.
34. When stopping the lathe, never grab the
workpiece or faceplate to slow it down. Let the
work coast to a stop.
35. Use only JET factory authorized replacement
parts and accessories; otherwise, the warranty
and guarantee are null and void.
36. Use proper extension cord. Make sure your
extension cord is in good condition. When
using an extension cord, be sure to use one
heavy enough to carry the current your product
will draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and
overheating. Table 1
(sect. 6.3) shows correct
size to use depending on cord length and
nameplate ampere rating. If in doubt, use the
next heavier gage. The smaller the gage
number, the heavier the cord.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible
machine damage.
This means that if precautions are not heeded, it may result in serious, or possibly even fatal,
injury.
SAVE THESE INSTRUCTIONS
2.0 About this manual
This manual is provided by JET, covering the safe operation and maintenance procedures for a JET Model
JWL-1840EVS Woodturning Lathe. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. Your machine has been
designed and constructed to provide consistent, long-term operation if used in accordance with the instructions
as set forth in this document.
This manual is not intended to be an exhaustive guide to lathe operational methods, use of after-market
accessories, choice of stock, and such. Additional knowledge may be obtained from experienced users or
trade articles. Whatever accepted methods are used, always make personal safety a priority.
If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our
web site: www.jettools.com.
Retain this manual for future reference. If the machine transfers ownership, the manual should accompany it.
Read and understand the entire contents of this manual before attempting assembly
or operation! Failure to comply may cause serious injury!