5
4.4 Machine description
Fig 1
A…………….Sawblade tension knob
B……………..Upper viewing window
C….Control wheel Upper blade guide
D……………..Machine lamp
E……………..Upper blade guard
F…………….. Rip fence
G……………..sawblade
H……………...Mitre gauge
I………………Blade tension lever
J………………Saw table
K………………Tracking knob L…………Wheel
locking blade guide M……………….…Switch
N……………..Motor assembly
O……………..Additional support
P……………..Dust extraction nozzle
Q…………….Knob for adjusting the
inclination of the table
Fig 2
5. Transport and start up
5.1 Transport and installation
For transport use a forklift or hand trolley.
Make sure the machine does not tip or fall
off during transport.
The machine is designed to operate in
closed rooms and must be placed stable
on firm and levelled ground.
The machine can be bolted down if
required.
For packing reasons the machine is not
completely assembled.
5.2 Assembly
If you notice any transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with a
mild solvent.
Rubber feet mounting
Before cutting, assemble the four rubber
feet to holes in the four corner of base
with bolts (M6x30), big flat washers 6, and
nuts (M6) as show in picture(Fig 3).
Fig 3
Mounting the additional support
- Insert the additional support into the
corresponding two holes in the side of
base.
- Align the holes in the supporting and the
surface of base.
- Secure the supporting with two bolts and
nuts. (Fig 4)
Fig 4
Mounting the working table:
- Remove the bolt and wing nut from the
hole located in the front edge of table.
(Fig 5)
Fig 5
- Carefully slide the table over the blade,
through the slot in the table. (Fig 6)
Fig 6
- Remove knob assembly from saw frame.
- Position table assembly on saw frame.
Re-install knob assembly.
- Secure table in position with table tilt
locking knob assembly.
- Using a combination square, set table
perpendicular to blade. Adjust table stop
if necessary.
- Set pointer at 0°.
- Insert and tighten the bolt and wing nut
into the hole located in the front edge of
the table. (Fig 7).
Fig 7
Install the fence:
- Raise the clamp on the fence assembly
to the up position.
- Place the fence on the table so that the
clamp is at the front of the table.
- Lower the fence clamp in order to lock
the fence in position on the table.
