Jet JWBS-14SF, Инструкция по эксплуатации и каталог запасных частей

Страница: 13 / 36

13
2. If adjustment is needed, loosen the hex nuts
on one of the two adjustment screws (E,
Figure 12) and turn the adjustment screw to
bring fence in line with miter slot.
3. Retighten hex nuts.
Figure 12
8.6 Leveling table insert
Refer to Figure 13.
Use a 2mm hex key to adjust any of three set
screws (A, Figure 13) until insert is level with table
surface. Place a straight edge across table and
insert to verify.
Figure 13
8.7 Table tilt
Refer to Figure 14.
1. Loosen lock handle (F).
2. Rotate handle (G) to align pointer (H) with
angle on scale.
NOTE: For left tilt (as viewed from front or
operator’s side of saw), push stop bolt bracket
(J, Figure 15) down.
3. Tighten lock handle (F) to secure setting.
NOTE: The lock handle (F) can be pivoted to
more convenient positions. Simply lift straight
out on handle and rotate it on the pin, then
release handle making sure it seats itself on
pin.
Figure 14
8.8 90° Table stop
Refer to Figures 14 and 15.
The 90° positive stop ensures that table will always
be perpendicular to blade after table is returned to
horizontal position. Check and adjust this 90° stop
as follows:
1. Disconnect machine from power source.
2. Make sure blade is under full tension.
3. Tilt table until it rests on stop bolt (K).
4. Loosen lock handle (F).
5. Place a square on table (Figure 15) and
against blade to check that table is 90° to
blade. Do not push square into blade.
Figure 15
6. If table and blade are not square, use a 13mm
wrench to loosen lock nut (L, Figure 14) then
rotate stop bolt (M). Turn stop bolt as needed
until there is no longer light showing between
square and blade.
7. Tighten lock nut (L) to secure table stop in
position.
8. Tighten lock handle (F).
9. Check that scale pointer (H) is at zero. If
necessary, loosen screw on pointer and shift
pointer to zero. Re-tighten screw.