Jet JSG-96, Инструкция по эксплуатации и каталог запасных частей

Страница: 8 / 24

8
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Sander is assembled
and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor.
Contents of Main Carton (708595)
1 Sander
1 Sanding
Belt
1 Sanding Disc
2 Tables
1 Center
Point
3 Handles
2 5/16”
Flat Washers
1 Miter Gauge
1 Owner's Manual
1 Warranty Card
Tools Required for Assembly
1 13mm Wrench or socket (for stand)
1 12mm Wrench or socket (for stand)
Assembly
Read and understand the
entire contents of this manual before
attempting assembly or operation of the
disc/belt sander. Failure to comply may cause
serious injury.
Consult the breakdown drawings at the back of this
manual if further clarification is needed on
assembly instructions.
Open Stand Assembly (Optional)
1. Match the hole patterns in the stand legs with
the hole patterns in the stand top pieces.
Mount the legs to the outside of the top pieces
using sixteen 5/16”x5/8” carriage bolts and
sixteen 5/16” lock nuts. Do not tighten until the
stand has been assembled and is sitting level
on the floor.
Note : Flange of long top pieces
overlap flange of short top pieces.
2. Install the leveling pads in the bottom hole of
legs with eight 3/8” hex nuts and eight 3/8” flat
washers.
3. Mount the belt rack to the stand by inserting
the 90° bend through the stand and securing
the rack in place with a 3/8”x3/4” hex cap bolt,
two 3/8” flat washers and a 3/8” hex nut.
Main Carton Contents #708595
Open Stand Contents #708596 (optional)
Closed Stand Contents #708597 (optional)