Jet JSG-96, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 24

6
Grounding Instructions
Electrical connections must be made by a qualified electrician in compliance with all
relevant codes. This machine must be properly grounded to help prevent electrical shock and possible
fatal injury.
In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified
electrician.
Improper connection of the equipment-grounding conductor can result in a risk of electric shock. The
conductor, with insulation having an outer surface that is green with or without yellow stripes, is the equipment-
grounding conductor. If repair or replacement of the electric cord or plug is necessary, do not connect the
equipment-grounding conductor to a live terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not completely
understood, or if in doubt as to whether the tool is properly grounded. Use only three wire extension cords that
have three-prong grounding plugs and three-pole receptacles that accept the tool’s plug.
Repair or replace a damaged or worn cord immediately.
115 Volt Operation
As received from the factory, your sander is ready to run at 115 volt operation. This sander, when wired for 115
volt, is intended for use on a circuit that has an outlet and a plug that looks like the one illustrated in (A). A
temporary adapter, which looks like the adapter as illustrated in (B), may be used to connect this plug to a two-
pole receptacle, as shown in (B) if a properly grounded outlet is not available. The temporary adapter should
only be used until a properly grounded outlet can be installed by a qualified electrician
. This adapter is not
applicable in Canada. The green colored rigid ear, lug, or tab, extending from the adapter, must be
connected to a permanent ground such as a properly grounded outlet box, as shown in (B).
Introduction
This manual is provided by JET, covering the safe operation and maintenance procedures for a JET Model
JSG-96 Disc/Belt Sander. This manual contains instructions on installation, safety precautions, general
operating procedures, maintenance instructions and parts breakdown. This machine has been designed and
constructed to provide consistent, long-term operation if used in accordance with instructions set forth in this
manual. If there are any questions or comments, please contact either your local supplier or JET. JET can also
be reached at our web site: www.jettools.com.