Jet JSG-6DC, Инструкция по эксплуатации и каталог запасных частей

Страница: 14 / 28

14
4. Rotate disc a half turn and press other half
of abrasive into place. Make sure to remove
any entrapped air by pressing all parts of
the abrasive against the disc.
Abrasive Belt
1. Disconnect machine from power source.
2. Raise the belt arm to vertical position.
3. Loosen lock screw and open left side panel.
4. Most brands of replacement abrasives are
directional, and must be installed in the
proper direction. Directional belts are so
indicated on the backing material by arrows.
The direction of the abrasive should match
that of the arrow on the platen assembly
(Figure 17).
NOTE: Failure to comply with abrasive belt
directional instructions may result in
premature belt breakage.
5. Once the belt direction has been
determined, pull the belt tensioning handle
toward you with one hand, while using the
other hand to slide the belt onto both drums
and over the platen pad. See Figure 17.
6. Center the belt on the platen and release
the belt tensioning handle.
7. Before operating, the belt should be tracked.
See “Belt Tracking Adjustment.”
Workstop Assembly
When the sanding belt is to be used in the
horizontal position, the table may be used as a
fence; or the table may be removed and the
workstop assembly installed.
Refer to Figure 18.
1. Remove table and trunnion assembly by
removing the table lock handle and washer.
2. Slide workstop bracket onto stud and fasten
with the washer and lock handle.
3. Adjust workstop to clear belt before starting
machine.
Figure 17
Figure 18