Jet JOSS-S, Инструкция по эксплуатации и каталог запасных частей

Страница: 7 / 24

7
6.0 Setup and assembly
The sander main unit requires no assembly. Set-up
involves only removing sander from pallet, and
installing desired table insert and spindle/sleeve
combination.
6.1 Shipping contents
Most of the below items can be found on or inside
sander cabinet. Some items are shipped in the small
box which accompanies the machine. One table
insert comes installed on the table.
Refer to Figure 1.
1 Spindle sander (not shown)
6 Table
inserts:
for 4” rubber drum (at 90°) – A
for 2” rubber drum (at 90°) – B
for 3/8” spindle (at 90°) – C
for 1/4”-to-3/4” spindle (at tilt) – D
for 1”,1-1/2”,2” rubber drum (at tilt) – E
for 3” and 4” rubber drum (at tilt) – F
1 Rubber drum with sleeve 4” – G
1 Rubber drum with sleeve 3” – H
1 Rubber drum with sleeve 2” – J
1 Rubber drum with sleeve 1-1/2” – K
1 Rubber drum with sleeve 1” – L
1 3/4" sleeve – M
1 3/4" Spindle – N
1 5/8" Spindle with sleeve – O
1 1/2 ” Spindle with sleeve – P
1 3/8" Spindle with sleeve – R
1 1/4” Spindle with sleeve – S
1 Spindle hex nut – T
1 Combination wrench (with magnet strip) – U
1 Hex wrench 3mm, and magnet strip – V
Note: All provided sanding sleeves are 100 grit.
Additional grits are available – see parts breakdown.
6.2 Additional tools required
Ratchet wrench with socket set (or adjustable
wrench)
Cross-point (Phillips) screwdriver
Machinist square
Straight edge
6.3 Unpacking and cleanup
Inspect all contents from shipping carton, including
parts inside cabinet (accessed through the side
door). Report any damage or part shortages to your
distributor.
Exposed metal surfaces, such as table surface,
have been given a protective coating at the factory.
This coating should be removed with a soft cloth
moistened with solvent, such as mineral spirits. Do
not use solvents with low flash points, or allow
solvents near plastic or rubber parts. Do not use an
abrasive pad as it may scratch exposed surfaces.
Periodically apply a light coat of paste wax or other
protectant to the table top to prevent rusting.
Figure 1