5
Laser class 2
<1mW, 400-700nm
Laser power supply
2 batteries AAA
4.2 Noise emission
(Inspection tolerance 4 dB)
Acoustic power level
(according to EN ISO 3746):
Idling
LwA 100,5 dB(A)
Acoustic pressure level
(according to EN ISO 11202):
Idling
LpA 87,7 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
This information is intended to allow
the user to make a better estimation
of the hazards and risks involved.
4.3 Content of delivery
1 mitre saw
2 table extension pieces
1 dust extraction bag
1 sawblade 24 tooth
Operating tools
Operating manual
Spare parts list
4.4 Mitre saw description
Fig 1
A….Unlock button
B….Motor housing
C….Workpiece fence
L….Table extension pieces
F….Machine table
G….Dust bag
H….Sawblade
I…..Bevel lock knob
J….Protective cover for blade
Fig 2
M….Handgrip with switch
O….Cutting head lock button
P….Bevel scale
R….Bevel lock knob
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate
in closed rooms and must be placed
stable on firm and levelled surface.
The machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Mounting the rubber pads
Press the 5 rubber pads (A, Fig 3 )
into the holes.
Fig 3
Mounting the table extensions
Use the screws (S, Fig 4) to lock the
table extensions ( L) in place.
Fig 4
Mounting the dust bag
Use the dust bag (G, Fig 1) to collect
the dust emissions. You can slide the
dust bag onto the dust port on the
rear of the machine.
The dust port is also suitable for the
connecting to a dust collector.
Unlocking the cutting head
The mitre saw is supplied with the
cutting head in locked position. The
cutting head lock button (O, Fig 2)
can be pulled out by pushing the
cutting head down at the same time.
Allow the cutting head to slowly rise.
The cutting head should be relocked
for transportation.
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked
H05VV-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Starting operation
You can start the machine by
pressing the trigger on the handle
with your fingers.
To stop the saw release the trigger.
6. Machine operation
Correct working position:
In front of the machine standing in the
direction of cutting.