Jet JBTS-10MJS, Инструкция по эксплуатации и каталог запасных частей

Страница: 22 / 40

22
Rip Fence Indicator
The rip fence indicator points to the scale on the
front of the table saw. The measurement shown by
the indicator will provide the user with accuracy up
to 1/16 of an inch. The measurement shown is the
distance from the blade to the side of the fence
closest to the blade.
To check the accuracy:
1. Measure the actual distance to the side of the
rip fence.
If there is a difference between the measurement
and the indicator, adjust the indicator as follows:
2. Loosen the indicator screw (A, Fig. 26).
3. Slide the indicator to the correct measurement
position on the scale, then retighten the screw.
Table Extension Scale Pointer
The table extension scale pointer (A, Fig. 27)
should be at 13 inches on the scale when the
extension is in the closed position. If adjustment is
required, loosen the
holding screw (B, Fig. 27),
position the pointer over the 13 inch marker and re-
tighten the screw.
Rear Table Extension Adjustment
The rear table extension (A, Fig. 28) should be
positioned as close as possible to the rear of the
table when ripping short material.
The rear table extension should be fully extended
when ripping longer materials that require extra
support.
Adjusting the Locking Lever
If the extension table moves when it is open and
locked in place, the
cam locking lever (A, Fig. 29)
may be loose and require adjustment.
To adjust the locking lever tension:
1. Hold the stud (B) stationary, and loosen the nut
(C) with a 10 mm wrench.
2. Rotate the rod using a wrench on one of the
flats (D). Do not overtension!
3. Re-tighten the nut (C).
Figure 26
Figure 27
Figure 28
Figure 29