Jet J-F225, Руководство пользователя

Страница: 10 / 20

10
Adjustments
Remove power when making
any adjustments. Failure to
comply may result in serious injury!
Performing Angle Cuts
The JET J-F225 can perform cuts at angles up to
45º to the left. Adjust the angle of a cut as follows
while referring to Figure 5:
1. Loosen two hex cap screws (A) with a 6mm
hex wrench to free the turntable.
2. Turn the machine body to any position between
0–45º, reading position on the angle scale on
the base.
3. Tighten the hex cap screws (A).
Blade Travel Adjustment
Tools required
‰
12mm wrench
‰ 13mm wrench
The height of retract and depth of cut stop adjust-
ments limit the upper and lower travel limits of the
saw blade.
To make adjustments (refer to Figure 5):
Height of retract – this is the upper travel limit of the
saw blade when the trigger handle is raised.
Adjustment is made by setting the position of
screw
B .
Depth of cut stop – this is the lower travel limit of
the saw blade when the trigger handle is brought
down. Adjustment is made by setting the position of
screw
C (not visible in photo).
Figure 5
Blade Guard Adjustment
Remove power when making
any adjustments. Failure to
comply may result in serious injury!
Referring to Figure 5:
When the saw head is lowered all the way, the
blade should not be visible (G). If the blade is
visible, the
blade guard (F) needs to be adjusted as
follows:
1. Loosen two socket head cap screws (D) just
enough to permit the bracket (E) movement for
adjustment.
2. Manually adjust the blade guard (H) until blade
is not visible at G.
Note: Durint step 2, the saw must be in the
lowered postion.
3. Tighten the two socket head cap screws (D).