Jet ETM-949, Руководство по эксплуатации

Страница: 22 / 52

22 MILL
10.7 SPINDLE PIN (COLLET RETENTION)
A spindle pin (set screw) protrudes into the interior of the
spindle to prevent a collet from rotating inside the spindle.
It has been set by the manufacturer to protrude 1.6mm be-
yond the interior spindle wall. However, collets may have
varied groove depths. If this pin needs adjustment:
1. Remove set screw at rear of quill with 2.5mm hex
key. See Figure 25.
2. Unscrew end cap from quill. (NOTE: Left hand
thread – clockwise to remove). See Figure 26.
3. Adjust spindle pin to desired depth with 3mm hex key.
See Figure 27.
4. Insert collet to confirm the fit.
5. When satisfied, reinstall end cap and rear set screw.
Fig. 25
Fig. 26
Fig. 27