Jet DSAN4-1, Инструкция по эксплуатации и каталог запасных частей, Страница: 10 / 20

10
7.7 Adjustable handles
The handles (such as C, Figure 7-1) can be adjusted
to more convenient position; lift up handle and rotate
it on the pin, then release, making sure it reseats on
pin.
8.0 Operation
8.1 Operating controls
Refer to Figure 8-1.
Figure 8-1
A – Main on/off switch: Turns on main power to
machine.
B – Direction switch: Controls belt direction, center
position is neutral (belt does not move). To prevent
build-up of chips and debris on the belt, use
appropriate belt direction for each operation:
Notching – Direction 1
Grinding side – Direction 2
Grinding top – Direction 2
C – On button: Starts belt movement.
D – Off button: Stops belt movement.
E – Emergency stop button: Press for fast shut-
down of machine functions. To restart machine,
rotate button clockwise until it disengages.
9.0 User-maintenance
Always disconnect power to
machine before performing maintenance.
Failure to do this may result in serious personal
injury.
9.1 General maintenance
1. After each use, vacuum abrasive debris from
machine area. Wipe down machine with a clean
rag and apply light coat of oil to exposed metal
surfaces to inhibit rust.
2. Keep notching table and guide shaft areas
clean and free of debris. Use a brush to clear
shavings, not bare hands.
9.2 Lubrication
Note: Roller bearings are sealed and do not require
further lubrication.
See Figures 9-1 and 9-2.
1. Apply oil or grease to tension leadscrew and
contact points at hex nut.
2. Apply oil or grease to jaw leadscrew.
3. Apply grease to swivel base area.
4. Clean and apply oil to long and short guide
shafts.
Figure 9-1
Figure 9-2
9.3 Additional servicing
Any additional servicing should be performed by
authorized service personnel.