Jet DP-15M, Инструкция по эксплуатации и каталог запасных частей

Страница: 13 / 24

13
Generally speaking, the smaller the drill bit, the
greater the RPM required. Wood requires higher
speeds than metal. Metal is usually drilled at
slower speeds.
In dusty environments, frequently blow out any
dust that accumulates inside the motor.
Maintenance
Before any intervention on the machine,
disconnect it from the electrical supply by
pulling out the plug or switching off the main
switch! Failure to comply may cause serious
injury.
A coat of automobile-type wax applied to the
table and column will help to keep the surfaces
clean.
If the power cord is worn, cut, or damaged in
any way, have it replaced immediately.
Lubrication
All of the ball bearings are packed with grease at
the factory. They require no further lubrication.
Periodically lubricate the gear, rack, table
elevation mechanism, the splines (grooves) in
the spindle, and the teeth of the quill with a #2
tube grease.
Electrical
115 Volt Operation
Referring to Figure 16:
As received from the factory, your drill press is
ready to run at 115-volt operation. This drill
press, when wired for 115 volt, is intended for
use on a circuit that has an outlet and a plug that
looks like the one illustrated in (A). A temporary
adapter, which looks like the adapter shown in
(B), may be used to connect this plug to a two-
pole receptacle if a properly grounded outlet is
not available. The temporary adapter should
only be used until a properly grounded outlet
can be installed by a qualified electrician. This
adapter is not applicable in Canada. The green
colored rigid ear, lug, or tab, extending from the
adapter, must be connected to a permanent
ground such as a properly grounded outlet box.
Figure 16
230 Volt Operation
Referring to Figure 17:
If 230V, single-phase operation is desired, the
following instructions must be followed:
1. Disconnect the machine from the power
source.
2. The JET drill press motor has four
numbered leads that are factory connected
for 115V operation, as shown in (A). For
230V operation reconnect the leads as
shown in (B).
3. The 115V attachment plug (C), supplied with
the drill press, must be replaced with a
UL/CSA listed plug suitable for 230V
operation (D). Contact your local Authorized
JET Service Center or qualified electrician
for proper procedures to install the plug.
The drill press must comply with all local and
national codes after the 230-volt plug is
installed.
4. The drill press with a 230-volt plug should
only be connected to an outlet having the
same configuration as shown in (D). No
adapter is available nor should be used with
the 230-volt plug.
5. The bulb installed in the work light must be
rated for 230 volt power.
Figure 17